Skip to content
MT5MT4soonTradingViewsooncTradersoonNinjaTradersoonPythonsoon

Break-Even Win Rate: The Win Rate Needed for 1:2 Risk Reward

At 1:2 risk reward you need to win 33.3% of trades to break even, before costs. The general rule is break-even win rate = 1 ÷ (1 + R), where R is reward divided by risk. Spread and commission push that number up, most of all on tight stops: a 1:2 trade with a 10-pip stop and a 1.5-pip cost needs about 38%.

Break-even is the floor, not the goal. If your tested win rate sits close to it, normal costs and bad luck can turn a small edge into a steady loss. You need the after-cost number and a sample large enough to trust.

Where the break-even formula comes from

Measure every trade in units of risk, called R. A loss costs 1R. A win at a 1:2 ratio pays 2R. Over many trades with a win rate W, the average result per trade is:

W × 2 − (1 − W) × 1

Break-even means that average is zero. Set it to zero and solve: 2W = 1 − W, so 3W = 1, and W = 1/3 = 33.3%. Replace the 2 with any ratio R and you get the general rule, 1 ÷ (1 + R).

Put another way, at 1:2 each win pays for two losses. Out of every three trades, one win and two losses leave you flat. The risk reward calculator shows this break-even line for any entry, stop and target you type in.

Win rate needed for common ratios

The same formula gives the break-even line for any ratio. These are the numbers before costs:

Risk rewardBreak-even win rateWins needed per 10 trades
1 : 150.0%5
1 : 1.540.0%4
1 : 233.3%3.3
1 : 2.528.6%2.9
1 : 325.0%2.5
1 : 420.0%2

The full grid, showing the profit or loss per trade at each win rate, is in the risk reward vs win rate table.

How spread and commission raise the break-even win rate

Costs shrink every win and grow every loss by the same number of pips. With the stop, target and cost all in pips, the break-even rate becomes:

Break-even with costs = (stop + cost) ÷ (stop + target)

Here is a worked example with three 1:2 EURUSD trades, each with a round-trip cost of 1.5 pips (spread plus commission):

  • 10-pip stop, 20-pip target: (10 + 1.5) ÷ 30 = 38.3%
  • 20-pip stop, 40-pip target: (20 + 1.5) ÷ 60 = 35.8%
  • 40-pip stop, 80-pip target: (40 + 1.5) ÷ 120 = 34.6%

The ratio on paper is the same, 1:2, but the tight-stop version needs five more points of win rate just to stay flat.

Break-even win rate for a 1:2 trade with a 1.5-pip cost, by stop sizeIllustration
No cost
33.3%
40-pip stop
34.6%
20-pip stop
35.8%
10-pip stop
38.3%

Scale zoomed in to show the difference (bars do not start at zero).

To turn a commission into pips, divide the round-trip commission per lot by the pip value per lot. A $7 commission on EURUSD, where a standard lot is worth $10 per pip in a USD account, adds 0.7 pip. More on this in how spread changes your risk reward.

How much margin above break-even you need

A win rate measured on a few dozen trades is a rough guess. The statistical margin of error (one standard error) on a win rate is √(W × (1 − W) ÷ N), where N is the number of trades. For a 40% win rate:

Trades in the sampleMargin of error (±)Plausible range
2011.0 points29% to 51%
506.9 points33% to 47%
1004.9 points35% to 45%
2003.5 points36.5% to 43.5%

Read the table against the 1:2 break-even line. At 50 trades, a measured 40% could really be 33%, which is break-even before costs and a loss after them. At 200 trades, the low end of the range, 36.5%, still sits above the 35.8% after-cost line from the 20-pip example.

That gives you a practical rule:

  • If the low end of your range is above the after-cost break-even, the edge at that ratio is likely real.
  • If break-even falls inside the range, you need more trades before you can tell.
  • If the high end is below break-even, the ratio and hit rate do not work together as tested.

Mistakes when using break-even win rate

Using the ratio as drawn, not as filled. Slippage on stops and partial fills change the real R. Recompute W and the average R from your actual closed trades.

Mixing ratios. If half your trades target 1:1 and half target 1:3, one break-even number for the whole log is wrong. Split the log by setup, or use the average win and average loss in the trading expectancy formula.

Counting break-even exits as wins. A trade closed at entry after moving the stop is 0R, not a win. Counting it as a win inflates W and hides how often the target is really reached.

Questions

Is a lower break-even win rate always easier to beat?

Not by itself. A higher ratio lowers the break-even line, but it also moves the target further away, which usually lowers how often the target is hit. What matters is the gap between your real hit rate at that target and the break-even line, so test each ratio on the same setups.

Does the break-even win rate include swap?

No. Swap (overnight financing) depends on how long you hold and on the instrument, so it is not part of the formula. If your trades often stay open for several days, convert the average swap per trade into pips and add it to the cost term.

Can I break even with a win rate under 33% at 1:2?

Only if your real average win is bigger than 2R or your average loss is smaller than 1R, for example through trailing exits or early closes. In that case your true ratio is not 1:2; use the averages from your trade log instead.

Use the free risk reward calculatorRun your own numbers in a few seconds, with the full guide on the same page.