Skip to content
MT5MT4soonTradingViewsooncTradersoonNinjaTradersoonPythonsoon

Bid v Ask Price Explained: Where You Buy, Where You Sell, What It Costs

beginner7 min readNov 15, 20260 views
Learn Forex from zero · lesson 49 of 130 · chapter 1

The bid is the price you can sell at right now. The ask price is the price you can buy at. The ask is always the higher of the two. The gap between them is the spread, and you pay it on every trade. You buy at the higher price and sell at the lower one, so every new position starts slightly in the red.

Getting this wrong costs real money. Stops close "too early". Limit orders don't fill even though the chart touched your level. Small targets get eaten by a cost you never saw on a statement.

Bid is where you sell, ask is where you buy

Every quote has two prices because someone has to take the other side of your trade.

A currency exchange booth works the same way. It buys your euros at one rate and sells euros at a higher rate. You never get to buy at the low number and sell at the high one, and neither does a trader.

In market terms, the bid is the highest price a buyer is willing to pay right now. The ask is the lowest price a seller will accept right now. When you trade, you take those offers: you sell into the best bid and buy from the best ask.

The ladder below shows a EUR/USD quote. The prices are an example: 1.1000 bid and 1.1002 ask.

EUR/USD example quote: bid, mid and ask with the spread shadedIllustration
Spread 2 pipsAsk (you buy)1.1002Mid (no fills here)1.1001Bid (you sell)1.1000

Look at the middle line. Some charts and news headlines show this mid-point, but no order is filled there. Your order always fills at either the bid or the ask.

How to calculate the spread: Ask − Bid

The bid-ask spread is Ask − Bid. With the same example quote, 1.1002 − 1.1000 = 0.0002. On EUR/USD one pip is 0.0001, so this spread is 2 pips.

Many quotes show one more decimal, so the same quote reads 1.10000 / 1.10020. That last digit is a point (also called a pipette), and 10 points make one pip. This is why a spread readout can say 20 when the gap is 2 pips: it is counting points, not pips.

EUR/USD quote 1.10000 / 1.10020 with the fifth decimal (point) marked
The fifth decimal is the point (pipette). A spread readout of 20 counts points, so the gap is 2 pips.

The spread is built into the two prices, not charged as a fee.

Which price opens, closes and triggers each order

Most short explanations skip this part. It explains most "my broker cheated me" moments. Every order is tied to one side of the quote.

What happensPrice used
Open a buy (long)Ask
Close a buyBid
Open a sell (short)Bid
Close a sellAsk
Buy limit or buy stop triggersWhen the ask reaches it
Sell limit or sell stop triggersWhen the bid reaches it
Stop loss or take profit on a buyChecked against the bid
Stop loss or take profit on a sellChecked against the ask

The pattern is simple. Anything that buys uses the ask, and anything that sells uses the bid. This works for both sides of going long and short. Closing a short means buying, so it happens at the ask. Closing a long means selling, so it happens at the bid.

There is a catch. Many forex platforms draw their candles from the bid only, so the chart line you watch is the selling side. The ask stays hidden unless you turn on an ask line in the chart settings. For anything that buys, including closing a short, the chart is off by the size of the spread.

Worked example: what a 2-pip spread does to one trade

The figures here are an illustrative example. Say EUR/USD quotes 1.1000 bid and 1.1002 ask, and you buy 1 standard lot. On EUR/USD, 1 standard lot is worth $10 per pip.

  1. You buy at the ask: 1.1002.
  2. Your open trade is valued at the price you could close it at. For a buy, that is the bid: 1.1000.
  3. The gap is 2 pips, so your floating profit and loss shows −$20 as soon as you are filled. Nothing went wrong. That is the spread.
  4. You break even when the bid climbs to 1.1002, your entry price.
  5. Later the bid reaches 1.1030 and you close there.

The calculation below works through the numbers. The chart line moved 30 pips, from 1.1000 to 1.1030, but you keep only 28.

Example long trade on EUR/USD: the spread cost and the profit you keep
Spread in price1.1002 - 1.1000= 0.0002
Spread in pips0.0002 ÷ 0.0001= 2
Loss shown at entry (1 lot)2 × $10= $20
Exit bid minus entry ask1.1030 - 1.1002= 0.0028
Pips kept0.0028 ÷ 0.0001= 28
Profit on 1 lot28 × $10= $280
Profit after a 30-pip chart move$280

Now use the same example prices on a short. You sell at the bid, 1.1000, and put your stop loss at 1.1015. Later the chart's high reaches 1.1014, one pip below your stop. A short's stop is checked against the ask, though, and with a 2-pip spread the ask at that moment is 1.1016. That is above 1.1015, so your stop triggers. The drawing below shows how the trade closed even though the chart never touched the stop.

Short trade stopped out by the ask while the bid chart stays below the stop
The chart (bid) never reaches the stop, but the ask does, and a short's stop is checked against the ask.

You take the full stop-loss hit, even though the chart says price never got there. The stop didn't malfunction. It watched the ask, which is the price that closes a short.

Why spreads widen, and a rule for checking them

On most symbols the spread is not a fixed number. A floating spread changes all day with the market. A fixed spread is set by the broker. Floating spreads are usually tight on heavily traded pairs such as EUR/USD. They get wider:

  • On thinly traded symbols
  • When the market is volatile, such as around major news
  • Outside regular trading hours, then narrow again once the main markets open (see forex market hours)

A rule you can use before every entry: divide the live spread by your stop distance. The result is the share of your risk you lose to the spread before price moves at all. Say your stop is 10 pips and the spread is 2 pips: 2 ÷ 10 = 0.2, so 20% of your stop is used up at entry. Pick a ceiling you accept, for example 10%. If the spread is above it, wait, or use a wider stop with a smaller position.

The same 2-pip spread against 5, 10, 20 and 40-pip stops: red is above a 10% ceiling, green is within itIllustration
5-pip stop
40%
10-pip stop
20%
20-pip stop (at the 10% ceiling)
10%
40-pip stop
5%

Bid and ask on gold, stocks and bonds

The rule is the same in every market. Gold has a bid and an ask too. You buy at the ask and sell at the bid, just like a currency pair. The spread is still Ask − Bid, measured in gold's own price units.

Exchange-traded stocks and futures add a third number, the last price: the price of the most recent completed trade. On some platforms, pending orders and stops on these instruments trigger when the last price reaches them. You are still filled at the ask when buying or the bid when selling, so the last price you saw may not be the price you get.

Bonds are quoted the same way. A dealer shows a bid, the price they will pay for your bond, and an ask, the price they will sell one for. Bonds that trade rarely tend to have a wider gap, for the same liquidity reason as thin currency pairs.

Mistakes that cost beginners money

Wondering why a buy limit didn't fill. You set a buy limit at support, the candles touch it, and nothing happens. The bid touched your level, but the ask never fell that low. Fix: set buy limits above the level by the spread, or turn on the ask line so you can see it. The same applies to take profit on a short. It is checked against the ask, so the bid on the chart has to fall past your target by the size of the spread.

Bid candles touch a 1.1000 buy limit but the ask stays 2 pips above, so the order does not fillIllustration
Buy limit 1.1000 (support)1.1000Lowest ask 1.10021.1002Bid touches 1.1000 – no fill

Holding tight stops through news or quiet hours. Spreads can jump at those times. A stop that was safe at the normal spread can then be hit by the wider ask alone, or by the lower bid on a long. Fix: check the live spread before you enter, and don't hold very tight stops into scheduled news.

FAQ

Do I pay the spread when I open the trade and again when I close it?

No. You pay it once per round trip. You enter on one side of the quote and exit on the other, and that crossing is the cost. If the spread is wider when you close than when you opened, the exit costs you a little more.

Can the spread change after I've opened a trade?

Yes, if the spread floats. Your open trade is always valued at the price that would close it. A wider spread can therefore shrink your floating profit, or trigger your stop, even when the middle of the market hasn't moved.

Should I measure my stop from the bid or the ask when I size a position?

Measure from your real fill price to the price that will check your stop. On a buy, that is the entry ask down to a stop checked on the bid. On a sell, it is the entry bid up to a stop checked on the ask. Measured this way, the spread is already part of your risk, so your position size covers it.

Part of Forex basics: more guides, terms and free tools on this subject.