Skip to content
MT5MT4soonTradingViewsooncTradersoonNinjaTradersoonPythonsoon
Price action & SMC

Liquidity zone

Also called liquidity area, liquidity pool, resting liquidity, stop cluster

A liquidity zone is a price area where many pending orders cluster, mostly stop-losses and breakout entries resting just above swing highs or just below swing lows. Price is often drawn to it because large orders can be filled there.

The obvious place for your stop-loss is usually inside one of these zones. Knowing where the zone sits tells you where your stop should not be, and where price may reach before it turns.

What sits inside a liquidity zone

Sellers put their stops just above a recent high. Those stops are buy orders. Breakout traders place buy stop entries in the same place. So a band just above an obvious high holds a stack of buy orders: this is buy-side liquidity.

The mirror image sits below an obvious low. Buyers' stops and breakout sell entries are all sell orders, so that band is sell-side liquidity.

Buy-side liquidity above an obvious high and sell-side liquidity below an obvious low
Illustrative drawing: the stops and breakout entries sit just beyond the level, so the band above a high is all buy orders and the band below a low is all sell orders.

A large trader who wants to sell needs many buyers at once. The band above a high provides them. That is why price so often pushes into a zone, fills those orders, and only then shows its real direction. That run into the zone and back out is called a sweep.

The more traders can see the level, the more orders collect behind it. Two or three highs at almost the same price, called equal highs, build a thicker zone than a single high. Stops from the previous day's or session's trades also collect just beyond that day's or session's high or low.

Marking liquidity zones on your chart

Your chart does not show resting stop orders, and spot forex has no single public order book, so you infer the zone from price.

  1. Mark the obvious swing highs and lows, the previous day's high and low, and the current session's high and low.
  2. Draw a thin rectangle from each level outward: above a high, below a low.
  3. Extend the rectangle to the right until price trades through it.
Marking liquidity zones as thin rectangles beyond the previous day's high and low and a session swing high
Illustrative drawing: each band starts at its level, points outward (above a high, below a low) and runs right until price trades through it, as the swing-high band does here.

Keep the band narrow: just wide enough to cover where stops placed a little beyond the level would sit. On a quiet pair or a low timeframe it will be thinner; on a volatile one, wider.

How a liquidity zone changes one short trade

Using the steps above, you draw the band from 1.1000 to 1.1010. The figures here are an illustrative example: a pair makes a high at 1.1000 and another at 1.0999, and that band sits just above them. Your account is $10,000, you risk 1%, and one pip on one standard lot is worth $10.

Trader A sees a double top and sells at 1.0995 with a stop at 1.1005, inside the zone.

  • Stop distance: 10 pips. Size: $100 ÷ (10 × $10) = 1.00 lot.
  • Price spikes to 1.1012. The stop fills. Loss: $100, or more if the fill slips.

Trader B waits. The candle that reaches 1.1012 closes back at 1.0995, below the zone. B sells there with a stop at 1.1015, 3 pips above the spike high, and a target at 1.0965. The target sits 5 pips above the earlier swing low at 1.0960, just above the sell-side zone resting below that low.

The chart below shows the two highs, the zone above them, A's stop inside it, and the candle that runs through it and closes back underneath.

Liquidity zone above two equal highs, swept and rejectedIllustration
Trader B stop 1.10151.1015Trader A stop 1.10051.1005Target 1.0965 (above the 1.0960 1.0965Liquidity zone(resting buy ordeHigh 1.1000High 1.0999Trader A sells 1.0995 (doublSpike to 1.1012, close 1.099Trader B sells at the close,

B's numbers, step by step:

Sizing a short taken after the liquidity zone is swept
Risk in money$10,000 × 1%= $100
Stop distance in pips (entry to spike high, plus buffer)17 + 3= 20
Lots$100 ÷ (20 × $10)= 0.50
Profit if the 30-pip target fills30 × $10 × 0.50= $150
Order size0.50 lots

Both traders had the same idea, the same entry price and the same $100 at risk. The difference was that B's stop sat beyond the zone and the spike, and B's size was halved to pay for the wider stop. B's trade can still lose, but only if price pushes beyond the spike high, not on the run through the zone.

Checks before trading into or out of a zone

  • Treat the zone as a target, not a wall. The common misread is to see equal highs as strong resistance.
  • Decision rule. If a candle enters the zone and closes back out, treat it as a sweep and look for a trade away from the zone. If a candle closes beyond the zone and the next one holds there, the orders have been absorbed and the move is a breakout. Do not trade against it.
  • Stop placement. If your planned stop falls inside a zone, move it beyond the far edge and cut your size to keep the same money risk, or skip the trade.
  • Use the zone opposite your trade as a profit target, as Trader B did.
  • Check the time. Zones are often tested around session opens and scheduled news, when spreads can widen and fills can slip.
Sweep versus breakout: how candles close relative to a liquidity zone
Illustrative drawing: what decides it is where the candle closes. Back out of the zone means a sweep; beyond it, with the next candle holding, means a breakout.

FAQ

Which timeframe should I use to mark liquidity zones?

Start on the daily and 4-hour charts, where the highs and lows are visible to the most traders. Then drop to a 15-minute or 5-minute chart to watch how price behaves when it arrives.

Can I trade a liquidity zone again after price has swept it?

Not once price has run through the whole band: those orders are filled, so wait for a new high or low to form. If price only wicked partway in, the stops further out may still be resting. Keep the rectangle, but move its near edge to the tip of that wick.

What does "high liquidity zone" mean?

It is sometimes used for a price area where a lot of trading has already taken place, such as a long consolidation. That describes past volume. The zones in this entry describe orders still waiting to be filled.

Related terms