Average daily range
Also called ADR, Average daily trading range, Daily range average
Average daily range (ADR) is the average distance between each day's high and low over a set number of past days, usually measured in pips. It tells you how far a market normally moves in one day.
ADR helps you answer one question before you place a trade: is there still room for my target today? If your take-profit needs more movement than the market usually makes in a day, the trade only pays on an unusual day. Most days are not unusual.
How to calculate the average daily range
First take each completed day's range. Then average those ranges over your chosen number of days (N).
Daily range = Daily high − Daily low
ADR(N) = (Range day 1 + Range day 2 + … + Range day N) ÷ N
Most tools show ADR as one number in pips. Some also draw two levels on the chart, one ADR above today's low and one ADR below today's high. The value only changes once a day, when a new day closes.
Take an illustrative example on a major pair. Over the last five days, the daily ranges were 80, 95, 70, 110 and 95 pips. The first two steps of the calculation below turn them into one ADR figure. Then suppose today's low is 1.0950 and the high so far is 1.1010. The last three steps show how much room is left.
ADR versus average true range
The average true range (ATR) averages the true range instead. The true range stretches the day's range to include the previous close if price gapped beyond it. Forex trades around the clock on weekdays, so gaps are usually small and the two numbers stay close. The Monday open is the exception. Stocks and indices are different: they gap overnight, so their ATR reads noticeably higher than their ADR.
Use ADR to ask how far price can still travel inside today. Use ATR when a stop has to survive gaps. The ATR entry covers that indicator in full.
Reading ADR during the trading day
Keep track of two numbers: the range used so far (today's high minus today's low) and the ADR. The gap between them is the room left.
Decision rule for intraday trades:
- Less than half the ADR used: the day has room. Breakout and trend trades can still aim for normal targets.
- Half to three-quarters used: take only pullback entries, with targets that fit inside the room left.
- About three-quarters or more used: don't chase. Shrink targets or wait for a pullback.
- More than one full ADR used: the day is either worn out or a strong trend day. Stand aside until price shows which one it is.
Common misread: traders often treat the projected ADR level as support or resistance. It is only a measure of typical movement, and no orders have to sit there. Here is how to spot a trend day: price runs through the level without stalling and candles close beyond it. On those days, stop fading the move.
When ADR helps and when to skip it
Works well:
- Ordinary, two-way sessions where volatility has been steady for a few weeks
- Intraday trading on the 5-minute to 1-hour charts
- Setting take-profits and checking whether a breakout still has room
- Comparing several pairs to pick the one whose range fits your stop
- Any market with daily candles, though on stocks and indices overnight gaps are not counted in the range.
Avoid it or adjust:
- Days with major news such as central bank decisions or jobs reports, when the range can far exceed the average
- Right after volatility shifts sharply, because the average lags the new pace
- Holidays and thin sessions, which can cut a day's range short
- Trades held for several days. Use weekly ranges or ATR for those.
- Using it as a signal on its own. ADR gives no direction and no entry signal.
ADR trading setups with worked prices
Both setups use the same illustrative example: a major pair with a 90-pip ADR, taken from the calculation above.
Buying a pullback while range is left
The Asian session sets the low at 1.0950. By the London morning, price has reached 1.1010. That uses 60 pips of a 90-pip ADR and leaves about 30 pips. This is the half-to-three-quarters case of the decision rule, so the plan is a pullback entry with a target inside the room left. The chart below marks the plan.
- Entry trigger: price pulls back to 1.1000, then a 15-minute candle closes back above it. Buy at 1.1000.
- Stop loss: 1.0980, which is 20 pips below the entry.
- Exit: 1.1035, which is 35 pips of profit and stays 5 pips short of the 1.1040 projected high.
Skip the trade if price reaches 1.1030 before any pullback. Only 10 pips would be left, which doesn't pay for a 20-pip risk.
Fading a day that has already used its range
On another day, the low is 1.0900 and the high is 1.0995. That is 95 pips, more than one full ADR. In the New York session, price comes back to the high and stalls. The chart below shows that day on 1-hour candles, with the line one ADR above the low at 1.0990.
This is the "stand aside until price shows which one" case, resolving as a worn-out day. You don't sell at the 1.0990 line. It only tells you the day is stretched. The trigger is the rejection candle at the day's 1.0995 high.
- Entry trigger: a 1-hour candle rejects the 1.0995 area and closes at 1.0980. Sell at 1.0980.
- Stop loss: 1.1005, which is 25 pips away and 10 pips above the day's high.
- Exit: 1.0950, just above the midpoint of the day's range (1.0948), for 30 pips.
Choosing the ADR period for your trading style
ADR always comes from daily candles. Your chart timeframe only changes how you use it.
| Style | Charts | ADR lookback | Why |
|---|---|---|---|
| Scalping | 5- and 15-minute | 5 days | Follows this week's pace |
| Day trading | 1-hour | 10–14 days | Balances recent and steady data |
| Swing trading | 4-hour and daily | 20 days | Times entries only, not multi-day targets |
These are common choices, not fixed rules. Measure ADR in each market's own units (dollars or percent of price for gold, pips for FX pairs), and never copy pip stops from one market to another.
Practical ADR tips
- If your broker prints a short Sunday candle, leave it out of the average or merge it into Monday. It shrinks the ADR.
- Compare a 5-day ADR with a 20-day ADR. If the short one is clearly higher, volatility is expanding, so widen stops and cut position size. If it is lower, ranges are contracting and targets should be smaller.
- If your stop is under about a fifth of the ADR (under 18 pips on a 90-pip ADR), normal intraday swings can hit it. Widen it and cut the size, or skip the trade.
Quick ADR checklist
- Work out ADR from completed days only, with a lookback that fits your style.
- Measure the range used so far today and the room left.
- Make sure your target fits inside the room left.
- Check for news that could break the normal range.
- Size the position from the stop distance, not from the ADR.
FAQ
Why does my ADR differ from another trader's for the same pair?
You are most likely averaging different days. A 5-day and a 20-day lookback can give quite different figures. If your broker's day starts at another hour, each daily candle is cut at a different point, so every high, low and range shifts too. Match both settings before you compare numbers.
Is a pair with a bigger ADR better for day trading?
Not by default. Price moves more pips, but your stops also need more pips, so your position size shrinks and the money at risk stays the same. Pick the range that suits your stop size and the hours you trade.









